If the selected slot has no
Primary Code, the Mode
LED will flash green,
indicating that the controller
is ready to accept a Primary Code.
If the selected slot already has
a Primary Code but no
Secondary Code, the Mode
LED will flash red, indicating
that the controller is ready to accept a Secondary Code.
If the selected slot already has a Primary and Secondary
Code, you will hear a long beep and the controller will return
to Normal Mode.
4. Enter the 4-digit PIN that you want to assign as the Primary or
Secondary Code for this slot number. If the PIN that is entered is
valid the Mode LED will stop flashing and then the controller is
ready for you to enter the next 3 Digit slot number (refer to step
3) that you want to assign a code to.
5. Press the "#" key to move to the next slot number (refer to step
4). If you do not wish to continue enrolling codes, press the "#"
key twice and the controller will return to Normal Mode.
To Next Page
Loading...
