NOTE! Before you start drilling, make sure that there are no fuel or brake lines or
wiring looms behind where you intend to drill.
INSTALLATION EXPERIENCE
MOUNTING LOCATION
Your ATOM Series amplifier comes with mounting feet that need to be attached to the amplifier
before installation. Once the feet are in place, use the amplifier as a template and mark the four
screw locations. Use caution to ensure there are no objects behind the installation surface that may
become damaged during drilling. The amplifier should be protected from exposure to moisture and
direct sunlight. The best places to mount your amplifier are the trunk floor, under the driver’s seat,
or on the back of the rear seat, for alternate installation locations.
WARNING
We recommend you do careful planning before you start to install this equipment. Choose a location for the
amplifier which will allow plenty of air to circulate. Do NOT mount the amplifier upside down under the hat rack. In
the amplifier case, there are double mounting holes to make the installation job more manageable. The screws
supplied in the plastic bag are self-drilling when used with an electric screwdriver.
If the surface where you intend to mount the amplifier isn’t big enough, you can mount the amplifier on a separate
fiberboard or similar. This will also isolate the amplifier chassis from ground.
2
To Next Page
Loading...
