Need help?Do you have a question about the Precision Power PCX 2125 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power at 4 Ohms | 125W x 2 |
| RMS Power at 2 Ohms | 250W x 2 |
| Bridged RMS Power at 4 Ohms | 500W x 1 |
| Frequency Response | 20Hz - 20kHz |
| Crossover Frequency | 50Hz - 250Hz |
| Bass Boost | 0 - 18dB |
| Fuse Rating | 40A |
Guides users through diagnosing no sound issues based on LED status and wiring checks.
Steps to diagnose and resolve sound issues affecting only one channel by checking speaker connections.
Explains AP-IV and AM-V protection circuits and what conditions activate them.
Explains the necessity and selection of fuses for safe operation within 18" of the battery.
Provides instructions and warnings for routing signal and power wires to avoid noise and damage.
Provides instructions for establishing a proper ground connection to the vehicle chassis.
Details a formula and chart for determining the correct power wire gauge based on current draw.
Lists new and notable features of the PCX series amplifiers.
Identifies and explains the function of controls and connectors on the amplifier's front endplate.
Identifies and explains the function of controls and connectors on the amplifier's rear endplate.
Explains the Total Control X-over (TC-X) feature and its independent crossover capabilities.
Details the QBASS PLUS™™ bass boost feature, its controls, and frequency selection.
Explains how to bridge the amplifier for mono output and associated impedance requirements.
Details technical specifications including power bandwidth, THD, S/N ratio, and impedance.
Details power output for different models (PCX 2125, 2200, 2400) at various impedances.
Instructions for connecting power and ground wires securely using PowerLock connectors.
Warns about potential hearing loss or damage from extended use of high-powered audio systems.
Outlines the terms and conditions of the three-year limited warranty for the product.
To Next Page
