To Next PageTo Next Page
Need help?Do you have a question about the Precision Power PC2200 and is the answer not in the manual?
General| Damping Factor | >200 |
|---|---|
| Crossover Frequency | 50Hz - 250Hz |
| Bass Boost | 0-18dB @ 45Hz |
| Input Sensitivity | 0.2V - 6V |
| Low Pass Filter | 50Hz - 250Hz |
| Operating Voltage | 16V |
Details on warranty service, self-service voiding warranty, and dealer contact.
Warning about hearing loss from high-volume use and observing local sound ordinances.
Comprehensive technical data including power bandwidth, distortion, input sensitivity, and dimensions.
Details on crossover point, type, and alignment for specific models.
Ratings for continuous output power for PC2100, PC2200, and PC2300 at various impedances.
List of tools and parts needed for installation that are not supplied.
Specification of maximum fuse ratings for each amplifier model for safety.
Formula and example for calculating current draw based on amplifier output.
Chart to select minimum wire gauge based on current draw and wire length.
Critical safety instruction to disconnect the battery negative terminal before starting.
Guidelines for routing wires to prevent noise and physical damage.
Steps for preparing a metal surface and making a secure ground connection.
Instructions for connecting power and ground cables using the PowerLock connector.
Guide to connecting speaker wires to the PowerLock connector, ensuring correct polarity.
Identification of amplifier controls like inputs, gain, crossover, and outputs.
Explanation of using input attenuation for high-level inputs.
How to operate the QBASS™ control for bass enhancement.
Function of the button to enable/disable the 90Hz crossover.
Description of RCA outputs providing high or low pass signals.
Steps for connecting RCA cables and using input attenuation.
Explanation of the noise-canceling balanced differential input circuitry.
Detailed explanation of the QBASS™ control for 40Hz bass boost.
Information on the 90Hz crossover, HP/LP switch, and RCA output behavior.
Step-by-step guide for correctly adjusting the amplifier input gain.
How to bridge channels for a 4-ohm mono output and impedance considerations.
Information on the amplifier's heatsink and required clearance for cooling.
Steps to diagnose and resolve issues when no sound is produced.
Troubleshooting procedure for when only one channel outputs sound.
Explains reasons for amplifier shutdown like short circuits or thermal issues.
Diagram illustrating a system with stereo speakers and a mono subwoofer.
Diagram showing a system utilizing two amplifiers for different speaker sets.
Diagram of a system using external preamp, equalizer, and phase control.
Diagram of a complex audio setup with multiple processing units.
Illustrates the internal signal path and processing stages within the amplifier.
Details the three-year limited warranty for authorized and non-authorized installations.
Lists circumstances that void the warranty, such as serial number tampering.
Instructions for returning products for warranty service, including required documentation.
