Need help?Do you have a question about the Precision Power PCX 2400 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Signal to Noise Ratio | >100 dB |
| Input Sensitivity | 200mV - 6V |
| Bass Boost | 0 - 18dB |
| Crossover | Variable Low-Pass |
Guide to diagnose no sound issues based on LED status and wiring checks.
Procedure to identify if the issue is speaker wiring or RCA inputs.
Illustrates system design with advice on routing signal and power wires safely.
Critical safety warning about main fuse placement near the battery.
Explains Short Circuit and Thermal Protection modes of the AP-IV circuit.
Details on AM-V protection for temperature and impedance issues.
Requirement for minimum 2-inch clearance around cooling plenums for proper cooling.
Switch to select HPF/LPF/FULL function for speaker outputs.
Control to adjust crossover frequency for speaker output.
Connection points for RCA cables from source unit or line driver.
Control to match source unit output level to amplifier input.
Switch for high voltage input capability (4V-12V).
Buttons for selecting QBASS boost frequencies (30, 36, 44, 60Hz).
Switch to select HPF/LPF/FULL function for RCA outputs.
Control to adjust crossover frequency for RCA outputs.
Outputs provide HP/LP/Full; 30-4KHz to another amplifier.
Connection point for speaker PowerLock connector.
Requirement for minimum 2-inch clearance around cooling plenums for proper amplifier cooling.
Control to add bass boost up to +18dB at selected QBASS™™ frequency.
Port for plugging in the optional QBASS Plus™™ Remote knob.
Connection of power and ground cables to the PowerLock™™ wire connector.
Green light indicating that the amplifier power is ON.
Guide to determine current draw and recommended minimum wire gauge based on load.
Selection of QBASS™™ frequency centers (30, 36, 44, 60Hz) with a Q-Factor of 2.
Warning about using QBASS PLUS™™ only with strong subwoofer sections to prevent damage.
Optional remote control for QBASS™™ boost that mounts in the dash.
Details warranty coverage for authorized vs. non-authorized installations and exclusions.
Instructions for returning products for warranty service and contact information.
To Next Page
