5.17 Elliptical Fitness Crosstrainer
Page 47
Diagram 6.10 - Pillow Block Bearings
7. Thread and hand tighten the pillow block mounting nuts onto the mounting studs. Torque
the pillow block mounting nuts to 200 in/lbs.
8. Align and tension the step up and input belts per Procedure 4.2.
9. Replace the crankarm(s) per Procedure 6.10. If both crankarms have been removed, the
crankarm with the magnet must be reinstalled on the right hand side.
10. Replace the stairarms per Procedure 6.22.
11. Replace the rear covers per Procedure 6.1.
Input Pulley
Mounting Nut
Pillow Block
Bearing
To Next Page
Loading...
