5.17 Elliptical Fitness Crosstrainer
Page 71
Procedure 6.26 - Replacing the Gear Motor
1. Set the on/off switch in the “off” position and disconnect the power adapter from the EFX.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Remove the rear covers as described in Procedure 6.1.
3. Remove the lower PCA, and magnet assembly per Procedure 6.18, steps 4-10.
4. Remove the red and black wires from the gear motor.
5. Remove the set screw from the gear motor extension shaft (See Diagram 6.23).
Diagram 6.23 - Gear Motor Mounting
6. Remove the nuts that fasten the gear motor to it’s mounting bracket, remove the gear motor.
7. Set the replacement gear motor at it’s mounting position and replace and tighten the
mounting nuts removed in step 5.
8. Replace and tighten the extension shaft set screw.
9. Connect the red wire to the positive (+) terminal and the black wire to the negative (-)
terminal of the gear motor.
Set Screw
Extension Shaft
Gear Motor Mounting Nut
Gear Motor
To Next Page
Loading...
