EasyManua.ls Logo

Precor 5.37 - Heart Rate Target Zones Diagram; Using Touch-Sensitive Handrail Grips; Monitoring Heart Rate with Grips

Precor 5.37
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Owner’s Manual: Heart Rate Features 14
The calculation used for the heart rate target zone is:
(220 minus your age) multiplied by a percent.
For example:
Low range: (220 minus your age) multiplied by 55%
High range: (220 minus your age) multiplied by 85%
Refer to Table 1 in Using SmartRate.
Diagram 7: Heart rate target zones
After you put on the chest strap, face the display console
for a few seconds. This allows the receiver in the console
to recognize the signal from the chest strap.
•If Hr appears in the display, the EFX is detecting a signal,
but has not yet determined your heart rate. Make sure the
chest strap is positioned properly around your chest and
against your skin.
If you prefer to use the touch-sensitive handrail grips,
grasp both grips and wait five to ten seconds. Make sure
both hands are moist.
Note: When a signal is detected, the heart rate icon
flashes and a number appears in the HEART RATE
display and indicates your heart rate.
Always face forward on the EFX and use the stationary
handrail for balance. Keep upper body movement to a
minimum.
20 25 30 35 40 45 50 55 60 65 70 75
70
80
90
100
120
130
140
150
160
170
180
190
200
110
537_Owners Manual.book Page 14 Monday, August 6, 2007 9:08 AM

Table of Contents

Related product manuals