9.23, 9.27 Treadmill
Page 34
Procedure 6.2 - Replacing the Incline Platform
1. Set the treadmill’s on/off switch in the “off” position. Remove the AC power cord from the AC
outlet.
2. Carefully, lay the treadmill on either it’s left or right side.
3. Remove the bolt that fastens the incline motor to the lift platform. Care must be taken
throughout this procedure to not allow the incline motor’s lift tube to rotate. The incline motor
may require calibration if the incline motor’s lift tube has rotated.
4. Remove the two bolts that fasten the lift platform to the frame and remove the lift platform
from the treadmill. Refer to Diagram 6.1.
Diagram 6.1 - Lift Platform
5. Remove the bolts that fasten the wheels to the lift platform and remove both wheels from the
lift platform.
6. Unthread the rubber bumpers from the top front end of the lift platform.
Incline Motor
Mounting Bolt
Lift Platform
Mounting Bolts
Wheel
Mounting Bolt
To Next Page
Loading...
