9.23, 9.27 Treadmill
Page 8
Procedure 2.4 - U.S. Standard/Metric Selection
1. Set the on/off switch in the “on” position and remove the safety key from the console. Allow
the internal power supply to discharge, approximately 10 seconds, and then replace the
safety key on the console. Within 2 seconds of replacing the safety key, press the STOP,
INCLINE , SPEED keys, sequentially.
2. Press the ENTER key to toggle the selection between U.S. Standard and METRIC.
3. Press the ENTER key to save the selection.
To Next Page
Loading...
