Precor 9.35i - Procedure 6.2 - Replacing the Lift Platform

9.33i, 9.35i Treadmill
Page 30
10. Feed the three pin lift motor connector through the grommet in the lower PCA bracket and
insert it in the J7 connector of the lower PCA.
11. Insert the large lift motor connector in the J1 connector of the lower PCA.
12. Dress all of the above wiring into the appropriate wire clips along their routing.
13. Insert the AC line cord from the AC outlet. Set the treadmill circuit breaker in the “on”
position.
14. Check treadmill operation per Procedure 3.