9.33i, 9.35i Treadmill
Page 4
Procedure 2.1 - Accessing the Hardware Validation Program
The treadmill's diagnostic program consists of the following modes:
• Display Test
• Keyboard Test
• Heart Rate Test
• Lift Test
• Belt Speed Test
• Belt Power Test
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. Refer to diagram 2.1 below and press keys STOP,5,1,7,6,5,7,6,1, sequentially. On the 9.35i
either the function keys or the numerical keypad may be used.
3. The display will momentarily read DISPLAY TEST and then illuminate every LED on the
display. Check all LED positions to ensure that all of the LED’s are functioning. Press the
ENTER key to continue.
Diagram 2.1 - 9.35i Display
Key #1
Key #2
Key #3
Key #4
Key #5
Key #6
Key #7
Numeric
Keypad
To Next Page
Loading...
