9.33i, 9.35i Treadmill
Page 7
Procedure 2.2 - Accessing the Information Display Program
The information display will access the following data;
• Odometer
• Hour meter
• Software version
• Error log
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. Press the keys STOP,6,5, sequentially.
3. The display will momentarily read, ODOMETER.
4. The treadmill’s odometer will be displayed as 1234567 MPH or 1234567 KPH.
Note: The odometer data is stored in non-volatile memory on the upper PCA. If the upper PCA
is replaced the odometer data will be lost.
5. Press the ENTER key to proceed to the hour meter display.'
6. The display will momentarily read, HOUR METER.
7. The operating time of the unit will be displayed as 12345 HOURS. The operating time is
defined as total amount of time that the unit has operated in program modes with the drive
motor running. The hour meter is also used to provide the “time stamp” for the error code
log.
8. Press the ENTER key to proceed to the software version display.
9. The display will momentarily read, SW VERSION.
10. The
, keys will scroll through the software versions. The software versions will be
displayed as; UPPER APP SOFTWARE XX.X, UPPER BOOT SOFTWARE and LOWER
SOFTWARE XX.X.
11. Press the ENTER key to proceed to the error log.
12. The error log will store up to 10 error conditions. The errors are logged with the most recent
error in position one. When a new error condition occurs, each existing error is pushed down
one position in log. If there was an error in position 10 when a new error was logged, the
error that was in position 10 will be lost.
To Next Page
Loading...
