C944 Treadmill
Page 17
13. If the center of the wheel on the zero sense switch is above the widest point of the switch
actuator . . .
THEN . . . OTHERWISE . . .
Move the switch bracket down until Move the switch bracket up until the
the widest part of the actuator is widest part of the actuator is centered
centered on the wheel on the zero on the wheel on the zero sense switch;
sense switch; then continue with then continue with the next step.
the next step.
14. Tighten the socket head bolts and washers that secure the switch bracket to the lift platform
(see Diagram 4.2).
15. Replace the hood.
16. Check the operation of the treadmill as described in Section Three of this appendix.
IMPORTANT
If the electronic console displays the diagnostic message LIFT ERROR PRESS STOP when you
incline and decline the running bed to its maximum limits, repeat this procedure.
If readjusting the position of the switch actuator does not fix the problem, refer to Procedure 2.4
in this appendix.
To Next Page
Loading...
Need help?
General
