C944 Treadmill
Page 9
Procedure 2.3 - Changing Club Settings
This procedure allows you to change the following club settings:
• English Standard /Metric Units
Selecting United States standard units causes data to be displayed in feet, miles and
pounds. Data is displayed in meters, kilograms and kilometers if metric units are selected.
• Maximum Speed
This selection is used to artificially limit the maximum speed the treadmill can attain when a
user is working out.The C944 Treadmill can attain an absolute maximum speed of 12.0
MPH (20.0 KPH) for PWM units and 10.0 MPH (16.0 KPH) for SCR units. This speed selec-
tion mode cannot exceed these speeds, but rather speeds may be selected that are lower
than these maximums.
• Maximum Workout Time
This club selection is used to limit the maximum workout time the treadmill may be used
during a workout. The time may range from a minimum of 10 minutes to an absolute maxi-
mum of 240 minutes. The default from the factory is 60 minutes.
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. If you wish to verify the measurement standard the treadmill is currently using continue with
the next step. If you wish to change the measurement standard the treadmill is using, skip to
Step 5.
Checking the Measurement Standard
3. Press ENTER until the WEIGHT indicator light appears.
4. Watch the number displayed in the left display window while you press the SPEED
▲ key
five or six times.
Note:
If the treadmill is using United States standard units, the numbers in the left display window are
repeatable multiples of 5 (such as 160, 165, 170, 175, etc.). Otherwise, the treadmill is using
metric units.
To Next Page
Loading...
Need help?
General
