Precor C954i User Manual

page 47
COMMERCIAL PRODUCTS DIVISION
3. Turn ON the treadmill, press QUICKSTART, and then increase the running
belt speed to 3 mph (5 kph) by pressing SPEED ▲.
CAUTION: Stand to the side of the treadmill. The running belt begins
moving automatically after you press QUICKSTART.
4. Observe the running belt for a couple of minutes. The belt should be centered on
the running bed. A few inches from either side of the side rail platform.
CAUTION: If you hear any chafing or the running belt appears to be
getting damaged, stop the running belt immediately by pressing the
red STOP button. Contact Precor Customer Support.
5. If the belt needs additional alignment, repeat steps 1 through 4 of this proce-
dure until the belt is properly aligned.
6. Press STOP. To return to the Precor banner, press RESET.
STORING THE POLAR
®
CHEST STRAP
Store the chest strap transmitter in a place where dust and dirt cannot accumu-
late on it such as, a closet or drawer. Be sure to keep the chest strap protected
from extremes in temperature. Do not store it in an area that may be exposed to
temperatures below 32 degrees Fahrenheit.
SERVICING THE TREADMILL
Do not attempt to service the treadmill yourself except for the maintenance tasks
described in this manual. The unit does not contain any user-serviceable parts
that require lubrication. Refer to Obtaining Service on page 7.
LONG TERM STORAGE
When the treadmill is not in use for any length of time, turn it OFF. Ensure that the
power cord is unplugged from the wall outlet and is positioned so that it will not
become damaged or interfere with other equipment or people.

Precor C954i Specifications