Precor CLM 835 - Page 21

Assembling the Climber 19
Hardware Kit (not to scale)
Fasteners Quantity
Washer (⁵₁₆ -inch inside diameter, 0.688-inch outside
diameter)
4
Buttonhead screw (¹₂-inch) 6
Hex head screw (1-inch) 4
Sockethead cap screw (1¹₄-inch) 2
Phillips-head screw (³₄-inch) 3
Flat head hex drive screws (¹₄-inch x ⁵₈-inch) 4
End cap 2
Lower handrail boot 2