20 Assembling and Maintaining the CLM 835 Climber
Required Tools
Before beginning the installation, make sure you have the
following tools available:
Wire tie cutter
Phillips screwdriver
One ¹₂-inch combination wrench (open-end or box-end)
SAE Standard socket set
Standard set of hex keys
Assembling the Climber
A fish tape (a thin metal strip with a hook or clasp on one end,
available from professional hardware vendors) can be helpful
during this procedure.
To assemble the main climber mechanism:
1. Place the upright support on a flat work surface.
2. Remove the two hex nuts and washers that secure the
handrail clamp, then set them aside.
Figure 2: Removing handrail clamp nuts
To Next Page
Loading...
