Assembling the Climber 21
3. While your assistant holds the heart rate handlebar near
the display console, feed the heart rate cable through the
opening in the upright support. Pull the end of the cable
out through the top of the support and pass it through the
opening in the console mount as shown in the following
illustration. Place excess cable inside the upright support.
Important: Do not stretch, crimp, or damage the cables.
Cables damaged by improper installation will not be covered
by the Precor Limited Warranty.
4. Insert the handlebar flange onto the screws protruding
through the handrail clamp). Rotate the handlebar to align
it with the side screw holes.
Caution: Hold the handlebar upright until it is securely
fastened in step 6.
Figure 3: Threading the heart rate cable and moving the
handlebar into place
5. Thread the two hex nuts and washers (removed earlier)
back onto the screws.
Important: Do not tighten the two hex nuts at this time.
To Next Page
Loading...
