Use the following flowchart to navigate through the menu settings
on climbers.
SELECT UNITS
SET MAX PAUSE TIME
SET MAX WORKOUT TIME
RESET, 5, 6, 5, 1, 5, 6, 5
SELECT LANGUAGE
OK
[ ENGLISH]
[ U.S.]
[ 60 MIN]
[ 120 SEC.]
OK
▼
OK
OK
▼
OK
OK
▼
▼
PRECOR
SET COOL DOWN TIME
[ 5 MIN.]
DIAGS – SET CLUB PARAMETERS
OK
OK
OK
▼
OK
SET CUSTOM PROGRAM 1 [ RANDOM]
OK
Treadmill: Selecting Safety Code
Protection
When the equipment is shipped from the factory, the safety code
protection feature is disabled. If you enable the safety code, your
patrons will need to enter four number keys in sequence to begin
their exercise session and, on the treadmill, start the running belt. If
the correct keys are not pressed within two minutes, further access
is denied. For more information, refer to Entering the Safety Code.
1. At the
SAFETY CODE
prompt, press OK. Use the navigational
arrow keys to alternate between the two selections.
Setting Description
ENABLED
Causes the safety code prompt to appear prior to a
workout and when returning from pause mode.
DISABLED
Does not require a safety code to operate.
CAUTION: Do not assume the equipment is safe because of
safety code protection. Never leave children unsupervised
around the equipment.
2. When you are ready, press OK to accept the displayed setting
and move to the next feature. For further options, refer to the
table in Accessing Club Programming Mode and Changing the
Settings.
Product Owner's Manual: Club Features 19
To Next Page
Loading...
Need help?
General
