EFX576i Elliptical Fitness Crosstrainer Assembly Guide 5
Rear
view of
console
Attach the upright supports to the base frame using eight
buttonhead screws (A), eight split washers (D), and eight
washers (B). Finger tighten.
Ask your assistant to hold the display console above the
upright supports while you connect the cable. Remove and
discard the tape after you connect the cable.
Important: Place excess cable inside the upright support.
Have your assistant lower the display console while you align
the mounting brackets on the inside of the upright supports.
Fasten the display console to each upright support by
threading a buttonhead screw (A), washer (B), and split
washer (D) through opposite mounting holes. Check that the
base fasteners are loose before installing the display console
fasteners.
CAUTION: Make sure the display console screws are
properly threaded into the inserts. Do not cross thread.
The Precor Limited Warranty does not cover damage that
occurs during installation.
C
heck alignments and thread the remaining four display
console screws (A), four washers (B), and four split washers
(D). Wrench tighten with a ³⁄₁₆-inch hex key so the assemblies
come together, but leave room for adjustments.
When all fasteners are snug against the unit, begin at the base
and alternately wrench tighten all fasteners. Follow the
sequence from step 3 through step 7.
To Next Page
Loading...
Need help?
General
