EFX576i Elliptical Fitness Crosstrainer Assembly Guide 8
Level the EFX by placing it on a solid, flat surface.
Before allowing users on the EFX, make sure it does not wobble from
side to side.
CAUTION: To eliminate wobble, make sure the rubber pads are
in contact with the floor.
To remove any side-to-side movement, take the following steps.
1. Ask your assistant to tip the unit on its side.
2. Locate the two height adjusters at the front of the unit.
3. Rotate the height adjusters to raise or lower the unit.
Important: If the unit is placed on a slightly uneven surface,
rotating the height adjusters can help, but will not compensate
for extremely uneven surfaces.
4. When you are finished adjusting the EFX, ask your assistant to
gently lower the unit to the floor. Make sure the rubber pads are in
contact with the floor.
Verify that the heart rate display is operational.
1. Hold on to a stationary handrail and step on the foot pedals.
2. When you are comfortably situated, begin pedaling. A
pedaling speed above 40 strides per minute must be
maintained for several seconds.
3. Grasp both touch-sensitive handrail grips on the stationary
handrails.
4. Look at the HEART RATE display. After a few seconds, a
number appears indicating your heart rate.
Note: If a number does not appear in the HEART RATE display,
you may need to disassemble the unit and check the cable
connection. For troubleshooting tips, refer to the Product
Owner’s Manual.
To Next Page
Loading...
Need help?
General
