Precor Discovery DPL0624 - Attach Weights; Attach Weight Arm Horns; Attach Counter Weights; Attach Foot Plate

a. If the pop pin does not release in all positions, loosen the jam nut
and turn the adjustment nut counter clockwise, ½ turn (Figure 13).
Then tighten the jam nut
and retest.
b. Continue this process until the pop pin releases at all heights when the
load is removed from the shoulder fr
ame.
2. Remove all weights and lift the weightless shoulder frame. Depress the
release handle. The pop pin should not release with this load.
a. If the pop pin releases the weight arm, loosen the jam nut
and turn
the adjustment nut
clockwise, ½ turn (Figure 13). Then tighten the
jam nut and retest.
Figure 13
b. Continue this process until the pop pin does not release with the
handle depressed.
NOTE
In r
ar
e cases, it may be necessary to adjust the nut in ¼ turn incr
ements to
meet both
r
etest checks.
Attach foot plate
1.
Position the foot plate onto the base fr
ame.
2. Secure the plate using two bolts (Figure 14). Fully tighten the bolts.
Figure 14
Attach Weights
Attach weight arm horns
1. Slide the weight horn through the bumper and into the weight arm (Figure
15).
Figure 15
2. Position the second bumper against the inside of the weight arm and attach
the horn using one bolt . Fully tighten the bolts.
Attach counter weights
1.
Slide the counter weight into the back of the shoulder fr
ame and secur
e it
use two bolts and washers (Figure 16). Fully tighten the bolts.
Figure 16
6