Begin Assembly
NOTE
DO NO
T fully tighten the fasteners until instructed to do so.
Remo
ve shoulder pad pivot supports
Disconnect the pr
e-assembled shoulder pad assemblies (Figur
e 1).
Assemble the frame
1. Place the base frame on the oor where you plan to use the equipment.
2. Attach the rear upright to the base frame using four bolts
and washers
(Figure 2).
Figure 2
3. Attach the center frame to the base frame using two bolts and washers
and to the rear upright using two bolts and washers .
4. Fully tighten all bolts.
5.
In the center fr
ame br
ack
et, position the shoulder fr
ame support pivot to
align the br
ack
et and fr
ame openings. Slide the short axle through the base
of the shoulder frame support and attach the shoulder frame support using
two bolts
and two end caps (Figure 3).
NOTE
The axle should slide easily through the openings. If it does not, use a
rubber mallet to gently tap it through the opening.
Figure 3
Figure 1
To Next Page
Loading...
