Assembling the Equipment
7
2. Attach the base of the lift assembly using two ⁵₁₆-inch x ³₄-inch hex head
screws and two ⁵₁₆-inch flat washers. Partially tighten the fasteners.
Figure 6: Secure base of lift assembly
3. Tear the foam pouch off the ramp.
4. Attach the ramp to the yoke using two ³₈-inch x 2³₄-inch buttonhead cap
screws, two ⁵₁₆-inch washers, and two ³₈-inch lock nuts. Fully tighten the
fasteners using a ⁷₃₂-inch hex key and a ⁹₁₆-inch socket wrench.
Figure 7: Ramp to yoke attachment
5. Fully tighten the two fasteners at the base of the lift motor assembly using a
¹₂-inch socket wrench. Do not use the socket wrench extension in this step.
Figure 8: Fastener location at base of lift motor
6. Cut the tie wrap that secures the lift motor.
7. Connect the six-pin connector to its receptacle near the lift motor.
Figure 9: Six-pin connection
To Next Page
Loading...
