Precor EFX 5.17i - CROSSRAMP; Incline Movement

Owner’s Manual: Display Console 18
CROSSRAMP ▲ ▼ (EFX5.17i and EFX5.21i):
Press and hold the CROSSRAMP arrows to increase
or decrease the ramp incline from 1 to 14.
Changes to the ramp incline are not immediate. It takes
time for the lift to reach the target incline shown on the
display.
Table 2 shows the degree of incline for each
CrossRamp setting.
Table 2. Incline movement
Important: Ramp changes occur only when the foot
pedals are in motion. The number that appears on the
display indicates the selected range, not the degree of
incline. There is not a one-to-one relationship between
the degree of incline and the CrossRamp setting.
The incline setting affects the column height in the
program profile as shown in Diagram 7.
Diagram 7: Column height affected by changes in incline
Note: During the setup phase, pressing the CrossRamp
arrow keys will not affect the ramp incline. However, the
arrow keys do affect what appears on the display. Refer
to Selecting a Program.
Unit Incline Setting Degree of Incline
EFX517i 1 through 14 12° through 25°
EFX521i 1 through 14 13° through 30°
EFX519 Stationary Fixed at 20°
1 to 2
4 to 5
5 to 6
7 to 8
9 to 10
11 to 12
13 to 14
Column height
Incline Setting