Precor EFX 885 - Page 104

EFX 885, 835, 825
Service Manual 20039-166
Page 104
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
5. Remove the two screws that fasten the access panel to the console. See Diagram 6.5.3
Diagram 6.5.3 Console Access Panel
6. Remove access panel:
a. Treadmills: Lift the console off the maintenance and then position the console so that the back panel is
accessible and remove the back cover.
b. ook on the
dash weldment and remove the back. See Diagram 5.5.4.
Diagram 6.5.4 Maintenance Access Hook
7. Disconnect the Data cable, Auto Stop cable (Treadmill only), Stop Key cable (Treadmill only), Hand Held HR
Cable, Earth Ground wire and the Wireless HR Cable from the Upper PCA. See Diagram 6.5.5. Remove the
console from the maintenance access hook and place it on a flat work surface.
Mounting Plate Hook
Access Panel Mounting
Screws
Access Panel Mounting
Screws