EFX 885, 835, 825
Service Manual 20039-166
Page 95
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Diagnostic Menus - Table
At the Banner press PAUSE/RESET,
ENTER, PROGRAMS, INPUT
DOWN, INPUT UP, ENTER,
INPUT DOWN, INPUT UP, and
PROGRAMS sequentially.
BEEPER TEST will be displayed.
Press the GO key to select the test.
The display will prompt the user to test the beeper sound.
Press the GO key to start the test.
This test will send an audible sound to the speaker mounted in the headphone jack.
Press the ENTER key to stop the test.
Press the WORKOUTS/PROGRAMS
key to exit the beeper test.
Press the key to go to the next test.
KEYBOARD TEST will scroll across the display.
A representation of all of the keys on the console will be displayed. Pressing a
key on the console will cause the illuminated representation of that key to turn
off. Press all of the keys on the console to ensure that all of the keys are
functioning. The keyboard test will exit when all the keys have been pressed.
Press the key to go to the next test.
LCD TEST will scroll across the display
Press the GO key to select the test.
The unit will test all the different sections of LCD display screen then all sections
on, advancing through each section. Check the display to ensure that all LED
segments are illuminated.
Press the WORKOUTS/PROGRAMS
key to exit the LCD test.
Press the key to go to the next test.
HEART RATE TEST will scroll across the display
Press the GO key to select the test.
Grasp both of the heart rate grips on the handlebar, after a couple of seconds the
heart rate will be displayed in the heart rate and smart rate displays.
Use chest strap transmitter or a wireless heart rate transmitter to test the
wireless heart rate function, after a couple of seconds the heart rate will be
displayed in the heart rate and smart rate displays.
Press the WORKOUTS/PROGRAMS
key to exit the Heart Rate test.
Press the key to go to the next test.
MACHINE TEST will scroll across the display.
You may now proceed to the BRAKE
test, RPM test, BATTERY test,
STRIDE POSITION test, or STRIDE
COUNT RESET. Press the , key
until the desired test is displayed.
Press the key to go to the next test.
BRAKE TEST will scroll across the display.
Press the GO key to select the test.
The brake power bits information will be displayed in the Distance Field. This
information is used to help diagnose problems with the Eddy Current Magnet.
Press the WORKOUTS/PROGRAMS
key to exit the Brake test.
Press the key to go to the next test.
RPM TEST will scroll across the display.
Press the GO key to select the test.
Rotation count is determined by a zero crossing from one phase of the generator
and is represented as RPM in service mode. The count in service mode is real
time and should go to zero if you quit pedaling, which can help diagnose stride
count irregularities.
Press the WORKOUTS/PROGRAMS
key to exit the RPM test.
Press the key to go to the next test.
BATTERY TEST will scroll across the display.
To Next Page
Loading...
