EFX 885, 835, 825
Service Manual 20039-166
Page 61
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Press the BACK key to exit the U-
BOOT SW display.
Use the , keys to move to
move to HOUR METER.
The software part number will be displayed as XXXXX-XXX.
Press the BACK key to exit the U-
BASE SW display.
Use the , keys to move to
move to LOWER SW.
The software part number will be displayed as XXXXX-XXX.
Press the BACK key to exit the
LOWER SW display.
Use the , keys to move to
move to METRICS BOARD SW.
The software part number will be displayed as XXXXX-XXX.
Press the BACK key to exit the
Metrics BOARD SW display.
Use the , keys to move to
move to SER. NUMBER.
The serial number will be displayed. The serial number may be incorrect or
not displayed if the upper PCA has been replaced.
Press the BACK key to exit the SER.
NUMBER display.
Use the , keys to move to
move to USAGELOG.
A message will scroll describing the program, the number of times and the
number of minutes the program was used.
Use the , keys to move through
the list of programs
Press the BACK key to exit the
USAGELOG display.
Use the , keys to move to
move to ERROR LOG.
The quantity of errors in the log will be displayed.
The most recent error will be displayed first.
Use the , keys to move through
the list of errors.
The error messages will list the error name, the odometer reading (Strides)
when the error occurred and the hour meter when the error occurred.
If you wish to BACK the error log,
press and hold the QUICK START
key.
The message HOLD TO BACK ERRORS will be displayed. The error log will be
cleared when the message NO ERRORS is displayed.
Please note that the ERROR LOG may also be accessed at any time by
pressing and holding the BACK key for four seconds. If the error log does not
contain any errors, the message STUCK KEY will be displayed.
Press the BACK key to exit the
ERROR LOG display.
Press the PAUSE key to exit the
DIAGS-INFORMATION DISPLAY.
To Next Page
Loading...
