3. Disconnect the Positive (Red) and Negative (Black) battery terminal cables.
4. Remove the following LPCA interface cables:
a.
Disconnect the Generator (J1) cable .
b.
Disconnect the Eddy Brake (J7) cable .
c.
Disconnect the Lift (J3) cable .
d.
Disconnect the Battery (J9) cable .
e.
Disconnect the COMM Data (J2) cable .
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 175
6 Replacement Procedures
LPCA (Lower PCA) Board Replacement
To Next Page
Loading...
