Precor Experience EFX635 - Lift Side Cover Replacement

edges and lift upward to remove the cover.
Installation Instructions
1. Raise the crossramp to maximum incline using the System Tests - CrossRamp Test.
CAUTION:Do not raise the crossramp from within a workout. The crossramp will
automatically lower to the default level when the workout times out. This unexpected
action could cause personal injury to extremities underneath the crossramp or the
area around the lift motor.
2.
Position the Forward Frame Filler cover onto the frame weldment and press to lock
the fastener tabs in place. Secure using the two #3 Phillip screws.
3. Lower the crossramp to the default incline level using the System Tests - CrossRamp
Test
4.
Reinstall the Lift Rear cover , see "Lift Rear Cover Replacement " on page77.
5.
Reinstall the Accessory Tray cover , see "Accessory Tray Cover Replacement" on
page77.
6.
Reinstall the Goose Neck Gasket , Goose Neck cover , and Lift Top cover ,
see "Lift Front Cover Replacement" on page72.
Lift Side Cover Replacement
Lift Side Cover Replacement
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 80
6 Replacement Procedures
Covers and Panels Replacement