Precor Experience EFX635 - Exploded View; Procedure

Exploded View
ID Cover
1 Drive Belt
2 Belt Tension Adjustment Bolt
3 Idler Pulley Bolt
4 Idler Pulley
5 Generator Assembly
Specifications
System Component Specification
Single Stage Belt Drive Tension 93-100 lbs (42- 45 kgs)
Procedure
Review entire procedure before starting.
1. Remove the Drive Housing Covers, see "Drive Housing Covers Replacement" on
page88.
2.
Place the belt tension gauge onto the drive belt midway between the drive and gen-
erator pulleys and measure the belt tension. If the tension is within specification 93-100
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 48
5 Adjustment/Calibration Procedures
Single Stage Drive Belt Tension Adjustment