Precor Experience EFX635 - Page 185

Installation Instructions
1.
If removed, reinstall the AC Adapter (J4) cable ..
2. Reinstall the LPCA board using the two #2 Phillips screw fasteners.
3. Reconnect the following LPCA interface cables:
a.
Reconnect the Lift (J3) cable .
b.
Reconnect the Battery (J9) cable .
c.
Reconnect the Comm Serial (J2) cable .
d.
Reconnect the Generator (J1) cable .
e.
Reconnect the Eddy Brake (J7) cable .
4. Reconnect the Positive (Red) and Negative (Black) battery terminal cables.
5. Reinstall the LPCA/Battery module cover using the one #2 Phillips screw fastener.
6. Reinstall the Left Drive Disk cover, see "Drive Disk Covers Replacement" on page84.
7. Verify machine operation and return to service, see "Standard Service Menus" on
page19.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 177
6 Replacement Procedures
LPCA (Lower PCA) Board Replacement