page 10
Using the M9.1 or M9.2s Treadmill
3
As simple as using the M9.1 or M9.2s treadmill might seem, you should read this section so that
you can use it safely and effectively. This section provides information about the electronic console
features which include the following:
• information about the ON/OFF (I/O) switch
• instructions for using the magnetic safety key
• a brief description of the electronic console
• instructions for changing the display from U.S. Standard to Metric
• M9.2s only — instructions for selecting the Time or Distance prompt
Locating the ON and OFF Switch
Use the ON/OFF (I/O) power switch to turn the treadmill ON or OFF. This switch is located at the
front of the treadmill, near the power cord.
Note: You cannot turn ON (I) the treadmill until the magnetic safety key is placed in the ACTIVATE
position.
Using the Magnetic Safety Key
The magnetic safety key lets you stop the treadmill’s running belt. Use this key in an emergency or
when you are finished exercising. Pulling the key off the console or moving it to the OFF position,
has the same effect as turning OFF the treadmill using the ON/OFF switch. Once you remove the
key from the ACTIVATE position, the running belt slows to a gradual stop.
Important: Always attach the magnetic safety key to your clothing before each workout. Use the
clip provided on the end of the cord.
Diagram 11
Magnetic safety key
ENTER
Speed
Incline
Scan
STOP
Hold to Reset
Electronic console label
ACTIVATE OFF
Magnetic safety key
Before you can operate the treadmill, you must move the magnetic safety key to the ACTIVATE
position on the electronic console. See Diagram 11. The treadmill will not turn ON unless the safety
key is in this position.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
