Precor M9.1 User Manual

iv
Information Regarding International Use
FCC Communications Commission, part 15
The M9.1 or M9.2s treadmill has tested and it complies with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. The M9.1 or M9.2s treadmill generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
owner’s manual instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If the M9.1 or M9.2s treadmill does cause harmful interference to radio or television reception,
which can be determined by turning the M9.1 or M9.2s treadmill OFF and ON, you are encouraged
to try to correct the interference using one or more of the following measures:
• Reorient or relocate the receiving antenna for your TV, radio, VCR, etc.
• Increase separation between the M9.1 or M9.2s treadmill and the receiver (TV, radio, etc.).
• Connect the M9.1 or M9.2s treadmill into a different power outlet—on a dedicated circuit
different from the one used by the receiver (TV, radio, etc.). No other appliance should be
plugged into the same power outlet that the treadmill is connected to.
• Consult your dealer or an experienced radio/TV technician for help.
Canadian Department of Communications
“This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of Communi-
cations.”
“Le présent appareil numérique n’émet pas de bruits radioéélectriques dépassant les limites
applicables aux appareils numériques de la class B prescrites dans le Règlement sur le
brouillage radioélectrique édicté par le ministére des Communications du Canada.”
*Indiquer seulement la classe duappareils numériques correspondent à l’application visée.

Precor M9.1 Specifications

Power

motor power	1.5 hp continuous duty 90V DC
power requirements	50/60Hz, 120v AC single phase

Performance

speed range	0.5 to 9 mph (0.8 to 14.48 kph)
incline range	0 to 10% grade

Weight and Dimensions

length	67.75 inches (172 cm)
width	26.75 inches (68 cm)
height	43.5 inches (110.5 cm)
weight	192 lbs (87 kg)