5. Walk around to the rear of the unit and observe
the belt for a few minutes. The belt should be
centered on the running belt. If the belt drifts off
center, you must make adjustments (refer to
Adjusting the Running Belt).
Important: Failure to align the belt may cause the belt
to tear or fray, which is not covered by the Precor
Limited Warranty.
6. To stop the running belt, press the STOP switch.
7. Turn the treadmill off.
Adjusting the Running Belt
If you are unsure about adjusting the running belt, call
Precor Customer Support. Refer to Obtaining Service.
CAUTION: For your safety, use the power switch to turn
Off the treadmill before making any adjustments. Do not
adjust the running belt when someone is standing on the
unit.
To adjust the running belt:
1. Locate the right belt adjustment bolt in the rear
end cap of the treadmill. Refer to the following
figure.
Figure 38: Location of the adjustment bolt
Maintenance 71
To Next Page
Loading...
Need help?
General