How to reset the Active Status Light (ASL) on Precor Treadmill when it's solid yellow?
If the Active Status Light (ASL) on your Precor Treadmill is solid yellow, it indicates a non-fatal electronic/electrical issue. You can reset the ASL to solid blue by cycling power to the treadmill, using the Active Status Light submenu in the Hardware Validation menu, or by clearing the error code log.
How to reset PM belt maintenance reminder on Precor TRM 835.v2 Treadmill?
To reset the maintenance reminder on your Precor Treadmill when the Active Status Light (ASL) is pulsing blue, access Maintenance Test, then Treadmill Maintenance. Press and hold QUIKSTART until '1000 Miles' is displayed.
What to do if the Active Status Light (ASL) on my Precor TRM 835.v2 is yellow and pulsing?
If the Active Status Light (ASL) on your Precor Treadmill is pulsing yellow, it means an error has occurred or is occurring. Allow the Motor Controller (MC) to attempt to resolve the issue. If the problem persists, service is required.
What does it mean if the Motor Controller Light (MCL) on my Precor TRM 835.v2 is yellow?
A yellow Motor Controller Light (MCL) on your Precor Treadmill indicates a fault has occurred. Troubleshooting is required. The MCL can only be reset to green through the diagnostics menus.
What to do if Active Status Light (ASL) is pulsing blue on Precor TRM 835.v2 Treadmill?
If the Active Status Light (ASL) on your Precor Treadmill is pulsing blue, this indicates a problem with the running belt/deck. Belt/deck servicing or replacement is needed.
General| Incline Range | 0 - 15% |
|---|---|
| Console Type | LED |
| Heart Rate Monitoring | Contact and wireless |
| Maximum User Weight | 350 lbs |
| Motor | 4.0 HP Continuous Duty |
| Running Surface/Area | 22" x 60" |
| Speed Range | 0.5 - 12 mph |
Details on power connection requirements, circuit specifications, and grounding.
Essential safety precautions and warnings for operating and servicing the treadmill.
Methodology for identifying and isolating system issues, including self-tests and error codes.
Steps for approaching treadmill issues, noting status lights, error logs, and observations.
Procedure for diagnosing issues when the unit's or wall breaker trips.
Procedures for diagnosing issues when the drive motor does not start or runs rough.
Steps for adjusting running belt tension and tracking using tensioning gauges.
To Next Page