How to reset the Active Status Light (ASL) on Precor TRM 811.v2 when it's solid yellow?
If the Active Status Light (ASL) on your Precor Treadmill is solid yellow, it indicates a non-fatal electronic/electrical issue. You can reset the ASL to solid blue by cycling power to the treadmill, using the Active Status Light submenu in the Hardware Validation menu, or by clearing the error code log.
How to reset PM belt maintenance reminder on Precor TRM 811.v2 Treadmill?
To reset the maintenance reminder on your Precor Treadmill when the Active Status Light (ASL) is pulsing blue, access Maintenance Test, then Treadmill Maintenance. Press and hold QUIKSTART until '1000 Miles' is displayed.
What to do if the Active Status Light (ASL) on my Precor Treadmill is yellow and pulsing?
If the Active Status Light (ASL) on your Precor Treadmill is pulsing yellow, it means an error has occurred or is occurring. Allow the Motor Controller (MC) to attempt to resolve the issue. If the problem persists, service is required.
What does it mean if the Motor Controller Light (MCL) on my Precor TRM 811.v2 is yellow?
A yellow Motor Controller Light (MCL) on your Precor Treadmill indicates a fault has occurred. Troubleshooting is required. The MCL can only be reset to green through the diagnostics menus.
What to do if Active Status Light (ASL) is pulsing blue on Precor TRM 811.v2?
If the Active Status Light (ASL) on your Precor Treadmill is pulsing blue, this indicates a problem with the running belt/deck. Belt/deck servicing or replacement is needed.
Checklist to verify the treadmill's proper operation after maintenance.
Steps to enter service software modes on P10/P30 and P80 consoles.
Access code and details for hardware validation diagnostic tests.
Explanation of how the AC drive motor controller manages speed and torque.
Methodology for identifying and isolating treadmill system issues.
Steps to diagnose and resolve issues when the wall breaker trips.
Steps to diagnose and resolve issues when the treadmill's internal breaker trips.
Explanation of how error codes are generated, stored, and accessed.
Troubleshooting steps for input power and control related error codes.
Procedure for diagnosing issues when the drive motor does not start or runs rough.
Troubleshooting for communication errors between upper and lower PCAs.
To Next Page
General