© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 75
Figure 20: Removing the front corner cover.
Removing and Replacing the Side Trim
1. Set the treadmill circuit breaker in the off position and unplug the treadmill’s line cord from the
AC outlet.
2. Remove the hood.
3. Remove the front Corner Cover and the Deck Trim Landing.
4. Using your hands, pull back the top edge of the side trim to lift if off the plastic anchors.
5. Slide the side trim downward to separate it from the treadmill.
6. Install the side trim by lifting the bottom of the trim into the hooks on the anchors, then snapping
the top over the anchors hooks at the top.
7. Reinstall covers.
8. Check treadmill operation per, Checking Treadmill Operation.
To Next Page
Loading...
