Assembling the Treadmill 27
2. Insert the serrated portion of the clip into the hole located
under the front of the unit on either side of the power
switch.
Figure 13: Power cord placement under front of treadmill
3. Place the clips along the length of the power cord as
needed while you direct the cord to the power outlet. The
holes, found in the frame beneath the side rail, are spaced
12 inches (31 cm) apart along the length of the side rail.
Figure 14: Power cord placement under side of treadmill
Checking Treadmill Alignment and
Adjusting the Running Belt
Before you allow anyone to use the treadmill, you must check
the alignment of the running belt and adjust it as needed. For
more information, refer to Checking the Alignment of the
Running Belt and Adjusting the Running Belt in the Maintenance
chapter.
To Next Page
Loading...
