Page 12 For technical questions, please call 1-888-866-5797. ITEM 62548
SAFETY SETUP OPERATION MAINTENANCE
Starting the Engine
Before Starting the Engine
a. Inspect the equipment and engine.
b. Fill the engine with the proper amount and type of both oil and
unleaded gasoline treated with fuel stabilizer.
c. Make sure that the Forward and Reverse Clutch Levers are disengaged.
1. To start a cold engine, move the Choke to the
START position.
To restart a warm engine, leave the
Choke in the RUN position.
2. Open the Fuel Valve.
3. Rotate the Throttle Control clockwise to
halfway between the low and high position.
4. Turn the Engine Switch on.
Note: If engine does not start, check engine oil. Engine
will not start with low or no engine oil.
1
2
3
4
ON
To Next Page
Loading...