Page 13For technical questions, please call 1-888-866-5797.ITEM 62548
SAFETYSETUPOPERATIONMAINTENANCE
5. Grip the Starter Handle of the Engine loosely and pull
it slowly several times to allow the gasoline to flow into
the Engine’s carburetor. Then pull the Starter Handle
gently until resistance is felt. Allow Cable to retract fully
and then pull it quickly. Repeat until the Engine starts.
Note: Do not let the Starter Handle snap back against
the Engine. Hold it as it recoils so it doesn't hit the Engine.
6. Allow the Engine to run for several seconds.
Then, if the Choke lever is in the START position,
move the Choke lever very slowly to its RUN position.
Note: Moving the Choke lever too
fast could stall the engine.
IMPORTANT: Allow the Engine to run at no load for five
minutes after each start-up so that the Engine can stabilize.
7. Adjust the Throttle Control Lever as needed.
Break-in Period:
a. Breaking-in the engine will help to ensure proper equipment and engine operation.
b. The operational break-in period will last about 3 hours of use. During this period:
• Do not apply a heavy load to the equipment.
• Do not operate the engine at its maximum speed.
c. The maintenance break-in period will last about 20 hours of use.
• Change the engine oil after this period.
Under normal operating conditions subsequent maintenance follows
the schedule explained in the MAINTENANCE section.
5
6
To Next Page
Loading...