Pregis AirSpeed Ascent - Air Pump and Power Setup

AirSpeed
®
Ascent Operator Manual Tech Service Hotline: 886-904-6979 Original Instructions
November 2020
Copyright Pregis Corporation 7
All Rights Reserved
4.1.3 Installing Air Pump
Securely attach the Air Pump to the Air Hose using a slotted screwdriver or a 1/4" hex driver. Then
attach the Air Hose and Air Pump power to the rear of the machine. See Section 3.2.
4.1.4 Power On
Plug the AC power cord into the back of the machine. Insert power cord into a suitable outlet. Power
the machine on or off using the Power Switch on the rear of the machine. See Section 3.2.
DO NOT POWER ON MACHINE UNTIL IT IS SECURED.
Figure 6. Attaching Air Hose to Air Pump.
Figure 7. Connecting Air Pump to rear of machine.