Premier CT-1 - Performance Data Sheet; General Use Conditions; Recommended Replacement Parts and Change Interval

Page 7
Premier, Inc.
8716 W Ludlow Drive Suite #1
Peoria, AZ 85381
Performance Data Sheet
For specic claims to NSF Standard 53.
CT-1
GENERAL USE CONDITIONS:
1: System to be used with municipal or well water sources treated and tested on regular basis to insure
bacteriological safe quality. DO NOT use with water that is microbiologically unsafe or unknown quality
without adequate disinfection before and after the system. Systems certied for cyst reduction may
be used on disinfected water that may contain lterable cysts.
2: Operating Temperature: Maximum 100
o
F (40.5
o
C) Minimum 40
o
F (4.4
o
C)
3: Operating Water Pressure: Maximum 100-psi (7.43 kg/cm
2
) Minimum 10-psi
4: Turbidity: < 5 NTU
5: pH: 5 to 10
6: Maximum ow Rate: 0.50 gpm (1.89 lpm)
RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVAL:
Note: Depending on incoming feed water conditions replacement time frame may vary.
Description Units Change time Frame
1 Micron Carbonblock P-CB-1: CT-1 6 Months or 1350 gallons
California Proposition 65 Warning
WARNING: This product contains chemicals known to the Sate of California to cause cancer and birth
defects or other reproductive harm. (California law requires this warning to be given to customers in
the State of California.) For more information: www.watts.com/prop65