Page 5
Filter Change
Premier recommends changing the lter element at least every 6 months or 1350 gallons
(5100 liters).
NOTE: Use Premier’s replacement cartridges only. Other lters may look the
same, but only lters by Watts are manfactured to t your CT-1 lter unit in order
to ensure proper reduction of water contaminants.
NOTE: There will be water in the CT-1 Filter Housing. To prevent spillage, turn
the CT-1 upside down before removing Filter Housing from the base. See gure
D.
Step 1: Remove CT-1 lter housing from base
by unscrewing it in a clockwise direction
as shown in gure D.
Step 2: Slide out used Carbon Block and lter
cartridge gaskets and discard.
NOTE: Do not discard the CT-1 lter
housing O-Ring.
Step 3: Clean inside the of the CT-1 filter
housing with warm soapy water. Rinse
the CT-1 Housing with warm clean
water to remove soap.
Step 4: Lubricate lter housing O-Ring with a
water-soluble lubricant (i.e. K-Y Jelly
® or Silicone lubricant) NOTE: Do not
use Petroleum based lubricant (i.e.
Vaseline ®).
Step 5: Seat O-Ring into lter housing grove.
Step 6: Slide new filter cartridge into filter
housing and screw CT-Filter housing
onto base.
Step 7: Repeat Step D (From initial installation)
NOTE: For replacement lters or questions regarding installation or servicing,
contact: Premier Customer Service Department (toll free within the United States)
1-800-752-5582. (Outside the United States) 480-675-7995. M-F: 8:00AM – 5:00PM
MST. Replacement lters are also available online at: www.premierH2o.com.
COUNTER-
CLOCKWISE
TO TIGHTEN
CLOCKWISE
TO LOOSEN
Figure D
To Next Page
Loading...
