PRESONUS FireStudio Quick Setup

TS - TS
XLR (M) - XLR (F)
TRS - XLR (M)
TRS - XLR (M)
FW400
Microphone
Guitar
Headphones
Computer with FireWire Active Monitor Speakers
The FireStudio Mobile enables you to simultaneously
record and play back up to ten channels. You can
plug two microphones directly into the FireStudio
Mobile’s two preamplifiers and can use the line-
level inputs to connect external microphone pream-
plifiers, such as the PreSonus BlueTube DP, Studio
Channel, Eureka, or ADL 600. These line inputs can
also be used to connect synthesizers, amp-
modeling hardware, etc. External analog-to-digital
converters can connect to the S/PDIF inputs. This
makes recording extremely easy. All you need are
microphones, cables, and monitor speakers.
FireStudio Mobile Basic Setup
Cables and Connectors:
1 XLR (M) -XLR (F) (mic cable)
1 FireWire 400 (computer cable)
1 TS - TS (guitar cable)
2 TRS - XLR (M)

PRESONUS FireStudio Specifications

Microphone Preamp

frequency response (+0, -0.5dB)	20Hz to 50kHz
frequency response (+0/-3.0dB)	20Hz to 150kHz
input impedance	1600 Ohm
THD + N	< 0.003%
EIN	-126dBu
S/N ratio	>101dB
common mode rejection ratio	>55dB
gain control range	-6dB to 55dB
maximum input level	+17dBu
phantom power	+48VDC

Instrument Input

input impedance	1 Mega Ohm

Line Inputs

frequency response (+0, -5dB)	20Hz to 50kHz
frequency response (+0/-3.0dB)	20Hz to 150kHz
input impedance	10 KOhm
THD + N	< 0.003%
S/N ratio	>101dB
gain control range	-9dB to +12dB
maximum input level	+23dBu

Digital Audio

ADC dynamic range	107dB
DAC dynamic range	110dB
bit depth	24
reference level for 0dBFS	+18dBu
internal sample frequency selections	44.1, 48, 88.2, 96 kHz
BNC word clock output level	4.5V
BNC word clock input level range	3.0 to 5.5V

Clock

jitter	<20ps RMS (20 Hz – 20 kHz)
jitter attenuation	>60 dB (1 ns in => 1 ps out)

Power

input voltage range	18 to 30 VDC
power requirements (continuous)	24W
external switching power supply	90-230VAC / 35W