Need help?Do you have a question about the PRESONUS FIREBOX and is the answer not in the manual?
Preamp Specifications| preamp bandwidth | 10Hz to 50kHz |
|---|---|
| preamp input impedance | 1.3k Ohms |
| preamp THD | <0.005% |
| preamp EIN | -125dB |
| preamp gain | 45dB |
Input and Output Impedance| instrument input impedance | 1M Ohms |
|---|---|
| line input impedance | 10k Ohms |
| TRS output impedance | 51 Ohms |
| TRS main outputs impedance | 51 Ohms |
Power| phantom power | 48V +/- 2V |
|---|---|
| power supply | Ext line Transformer, Internal Switching |
| bus power | Six-pin FireWire Port |
Digital Conversion| analog to digital converters | 24-bit / up to 96khz |
|---|---|
| ADC dynamic range | 107db |
| DAC | 24-bit / up to 96kHz |
| DAC dynamic range | 110db |
Details the terms and conditions of the limited warranty for the FIREBOX product.
General introduction to the PreSonus FIREBOX recording interface and its capabilities.
Specifies the minimum hardware and OS requirements for Windows and Macintosh.
Step-by-step guide for installing the FIREBOX audio drivers on Windows XP.
Instructions for accessing and opening the FIREBOX Hardware Control Panel on Windows and Mac.
Details on Sample Rate, Clock Source, Latency, and Input Level Boost settings.
Guide for installing and configuring the FIREBOX control panel on macOS.
Instructions for launching the FIREBOX Mixer software on Windows and Macintosh.
Guide to setting up the FIREBOX with Cubase LE software.
Steps to select the PreSonus ASIO driver within Cubase LE's device setup.
Instructions for creating a new project and testing the FIREBOX connection.
Guide on creating audio tracks and enabling recording within Cubase LE.
Steps for connecting a microphone, setting levels, and enabling track monitoring in Cubase LE.
Detailed explanation of the FIREBOX's front panel controls and connectors.
Explanation of Input Gain/Trim, Main Level, Headphone, and Power/Sync lights.
Description of the FIREBOX's rear panel connections and power inputs.
Explanation of MIDI, S/PDIF, Line Outputs, Main CR Output, and Line Inputs.
Introduction to the FIREBOX software mixer/router for flexible monitoring and routing.
Example setup for achieving zero latency recording using the FIREBOX mixer.
Explanation of input functions like Pan, Level, Solo, Mute, and Link within the mixer.
Details on the software playback channel and its functions within the mixer.
Explanation of output level, global clear functions, and output routing options.
Information on using dynamic, ribbon, and condenser microphones with the FIREBOX.
Visual guide showing typical connections for microphones, instruments, and computers.
Diagnosing and resolving pops, clicks, and distortion related to sync issues.
Troubleshooting sync problems on Mac and addressing audio dropouts on Windows.
Solutions for no signal from the microphone input, including checking cables and phantom power.
Addressing power-related problems and information on Cubase LE support.
Detailed technical specifications of the FIREBOX audio interface.
To Next Page
