Need help?Do you have a question about the PRESONUS FIREPOD and is the answer not in the manual?
Preamp Specifications| preamp bandwidth | 10Hz to 50kHz |
|---|---|
| preamp input impedance | 1.3k Ohms |
| preamp THD | <0.005% |
| preamp EIN | -125dB |
| preamp gain | 54dB |
| preamp send output impedance | 51 Ohms |
| preamp return input impedance | 10K Ohms |
Line and Output Impedance| line input impedance | 10k Ohms |
|---|---|
| TRS output impedance | 51 Ohms |
| TRS main outputs impedance | 51 Ohms |
| TRS cue outputs impedance | 51 Ohms |
Power and Performance| phantom power | 48V +/- 2V |
|---|---|
| power supply | Ext line Transformer, Internal Switching |
| headphone output | 150mW/Ch 20Hz-20kHz |
Converters and Digital Specifications| analog to digital converters | 24-bit / up to 96kHz |
|---|---|
| ADC dynamic range | 107db |
| DAC | 24-bit / up to 96kHz |
| DAC dynamic range | 110db |
| IEEE1394 speed | 400mbps |
Details the terms and conditions of the limited warranty provided by PreSonus for the FIREPOD.
Introduces the FIREPOD as a 24-bit 96K recording interface with eight microphone preamplifiers.
Lists the minimum system requirements for Macintosh computers to use the FIREPOD interface.
Specifies the minimum system requirements for Windows XP computers for FIREPOD operation.
Details the step-by-step procedure for installing FIREPOD drivers on Windows XP systems.
Provides specific details and screenshots for the FIREPOD driver installation on Windows XP.
Guides on connecting the FIREPOD and completing the Found New Hardware Wizard for drivers.
Explains how to access and configure the FIREPOD Control Panel in Windows XP.
Guide for installing and selecting the FIREPOD ASIO driver within CUBASE LE software.
Steps to test the FIREPOD by creating a new project and adding an audio track in CUBASE LE.
Describes the front panel controls including microphone pre-amplifiers, phantom power, and combo connectors.
Explains the input gain/trim controls, headroom, and the clip indicator function.
Details main output, mix, headphone controls, and power/sync indicator lights.
Describes back panel connections: power, FireWire, S/PDIF, MIDI, and audio I/O.
Explains the 1/4" TRS send/return jacks for external processors and line level devices.
Discusses compatibility with different microphone types and phantom power application.
Details how to use the Send and Return jacks for connecting external audio processors.
Illustrates a typical setup for recording a full band using the FIREPOD's multiple inputs.
Addresses issues causing pops and clicks, including sync problems and high CPU loads.
Provides solutions for 'No Sync' errors on Macintosh systems using Audio MIDI Setup.
Explains causes of audio drop outs and suggests lowering FIREPOD's CPU setting on Windows XP.
Troubleshoots no signal from microphones, input selection, and power-related problems.
Lists detailed technical specifications for the FIREPOD's performance and features.
To Next Page