Prestige APS-596E - Optional Remote Functions; Optional Device Output (Channel 3); Alternate Channel 3 Output; Additional Remote Functions (Channel 4)

128-9315
11 of 20
Page 11
1. Press and hold the ARM or DISARM button on the keychain transmitter for 3 or
more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM or DISARM button on the transmitter
again for 3 seconds. If the button is not pressed, the alarm will automatically
stop after 30 seconds. Also if any transmitter button other than the ARM or
DISARM button is pressed and released, the Panic mode will be turned off
immediately. The normal function of this transmitter button will be suspended
during the Panic sounding period.
3. During the panic mode, the Lock and Unlock buttons can be used to lock and
unlock the doors, (if the option is installed), however once the unlock/disarm
button is pressed, the vehicle's starter inhibit device, (where installed) will be
disabled allowing the vehicle to start.
NOTE: While in the Panic mode, pressing and releasing the ARM or DISARM buttons
will, if the option is installed, lock and unlock the doors respectively. While
in the panic mode, anytime the DISARM button is pressed, the panic feature
will continue for the allotted 30 seconds, however, the security system will
be disarmed allowing the vehicle to start.
OPTIONAL DEVICE OUTPUT ( CHANNEL 3 )
Controlled By: Trunk/Key Button
Other Transmitter button congurations are also available. Consult your installation
center for other congurations not listed above that may have been programmed
to operate a specic feature of your system.
This security system is equipped with an output which will activate when the appro-
priate transmitter button is depressed for 4 seconds. Although this output is intended
to activate the trunk release option, any other optional devices may be connected to
this channel. Consult your installation center for more information about this output.
ALTERNATE CHANNEL 3 OUTPUT
Channel 3 alternate is an alternate output that can be controlled by pressing the
trunk/key button 2 times in succession. The intent of this alternate channel is for
upgrade remote start systems when added.:
ADDITIONAL REMOTE FUNCTION ( CHANNEL 4 )
Controlled By:  Trunk/Key Button  Option Button  Lock + Unlock Buttons 
Lock + Trunk/Key Buttons  Unlock + Trunk/Key Buttons
Other Transmitter button congurations are also available. Consult your installation
center for other congurations not listed above that may have been programmed
to operate a specic feature of your system.
This security system has an additional feature that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are:
 Remote Car Starter