Prestige APS-997C - Remote Start Selectable Features; Feature Selection

128-8775
3 of 28
3
To exit program mode, turn ignition off, or press and release valet switch. RF Programmable Features Bank 3 Is Remote Start Selectable Features: Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Chirps 6 Chirps 1st Defrost Output Pulsed 10 Mins 2nd RF Start Chirp Off On 3rd Run Time 5 Mins 10 Mins 15 Mins 20 Mins 45 Mins 60 Mins 4th Parking Lights On Steady Flashing 5th Input Check Voltage Tach DBI Tach Hybrid 6th Voltage Level >0.5V B4 Start < 0.5V B4 Start 7th Ign. 2 Select Off During Crank On During Crank Same As Accy. 8th Ign. 3 Select Off During Crank On During Crank Same As Accy Same As Starter 9th Diagnostics Off On 10th Crank Time 0.8 Sec 1.0 Sec 1.5 Sec 2.0 Sec 11th Gas/Diesel Gas Diesel 10 Diesel 15 Diesel 20 12th Transponder O/P While R/S On During Start Until Ign. Off 13th Temp Start Off On 14th Crank Averaging Averaging Preset Time Note: When averaging, the engine must be started 4 times with the key to be effective. 15th R/S Shock Shunt Unit Clear Shunt R/S Cycle Shunt From Tx 16th Turbo Select Off 3 Mins 5 Mins 10 Mins 17th Black/Blue (Aux O/P) Single Pulse As Feature #1 18th One or Two Press Start Two Press One Press Note: When feature #5 is set for Voltage or Hybrid, the unit must also have feature #14 set for Preset Time or the unit will flash the Pk. Lts. 7 times and not start. When using the RF programmer, enter the program mode as follows: Turn the ignition on. Press and release valet switch 3 times. Turn ignition off then on. Press and hold valet switch for 5 seconds. Siren chirps 2 times indicating access to RF feature program mode. To exit program mode, turn ignition off, or press and release valet switch.